 |
 |
 |
|
The Fusion Brain has 16 digital on/off outputs and 13 analogue sensor inputs. The free Fusion Control Centre software from the software section interacts with the board to create the possibility of animated outputs, and graphical input displays. Requires unregulated or regulated 12vDC supply - can be connected straight to car battery, or to regulated 12v source. Can withstand power fluctations from 9v to 15v on the input.
Sensors can be connected to any one of the 13 analogue inputs for readings varying from Temperature to Distance to the amount of Light present.
Relays or LEDs can be connected directly to any of the board's 12 digital outputs header pins allowing for easy installation. Additionally, all 16 outputs are PWM capable. With 500mA of output capacity, each output can drive LEDs or small motors at varying brightness/speeds with from the PWM. With the addition of a MOSFET driver such as the Fairchild FQP50N06, much larger motors can be driven. The FQP50N06, for example, can drive up to 50 amp loads.
Download The Manual
Improvements over Brain v3:
- 16 Digital Outputs
- 13 Analog Inputs
- Selectable Power Source (USB or 12vDC Jack)
- 30% smaller form factor (70mm X 45mm)
- Better power filtering and protection
- Ability to update firmware via USB
- Ability to update firmware via ICSP header in event of bootloader corruption
- Improved signal routing for analog inputs
- Pulse Width Modulation, 256 steps with 42uS minimum pulse width (may need firmware update, provided free and uploadable over USB)
Please note:
Mp3Car will not provide tech support in regards to use and set-up of this product. Customers are expected to use the HYPERLINK
"http://www.mp3car.com/vbulletin"
Mp3Car forums for assistance in these areas.
|
|
|
|
|
|
|
|
|
