Install the sleeving over your wire bundle. Try to closely match the sleeving diameter to your bundle diameter so the bundle is fairly tightly managed. Leave about 2 of additional length to put through to the other side of the finished assembly.
Open the metal retaining ring and slide it over your bundle. Install the ring INSIDE of the sleeving so that the registration teeth protrude through the sleeving.
Take one of the locking collar halves (it doesn't matter which one... they're identical) and place it over the teeth on the retaining ring. It is important that the teeth of the retaining ring protrude into the appropriate holes in the locking collar. Hold it in place while you align the other half of the locking collar to the locking tabs on the ends of both halves. Squeeze the 2 halves together until both ends snap and lock together.
Smooth out the sleeving to allow the wall plate to easily slide up the length of the cable bundle. Slide the wall plate onto the assembly so that the side that faces the wall is against the locking collar. Snap the locking collar over the registration pins on the inside of the wall plate. Screw the wall plate into the workbox with the included color matched screws.How To Install the Flexo Mounting System►
Download this instruction sheet to learn how to install the Flexo Mounting System and create a secure and attractively managed through-wall cable bundle. Just click on the thumbnail to open the .pdf instruction sheet.a